Entranced at the Entrance






Pictures submitted by Bart Auten



'Keeping Young!





 Picture submitted by Allison Kincaid



Hive inspections are a valuable part of keeping your hives healthy and being a proactive beekeeper. Whether just checking in early spring, taking regular mite counts, or deciding whether to feed in the fall, there are some things to pay attention to every time you open your hive.


Here are some general things to look for during hive inspections:


Entrance activity before you open the hive can be telling - look for activity levels, pollen loads, interactions among the bees at the entrance, and anything else you notice. Below is a nice, clean entrance with relatively low activity, although there are a few visiting flies (this picture was taken on a cool evening and the gaurd bees were not letting those flies in!).


IMG 7746


Here is an entrance with a traffic problem - the bees are having trouble getting through the entrance reducer and mouse gaurd without losing their pollen loads and there are stains from a bee that didn't take off before defecating.


IMG 7412



As you open the hive, pay attention to things like odor, activity, and anything else in the hive (especially if there are other things in the hive - mice, beetles, larvae in weird places, etc. may be immediately indicative of a problem or secondary to something else going on in the hive).
Make a habit of counting the number of frames covered with bees in each box - this is easily done from above by counting the seams between frames that are full of bees.


IMG 6972 

Burr comb (filling spaces that are bigger than "bee space") and brace comb (going across spaces between frames) are worth noting as well. your hive is generally easier to maintain if you scrape burr and brace comb off when you have a chance. If this comb is left long enough, the bees will fill it with food or brood.


burr comb


As you go through frames, check each side for pollen, capped honey (white "dry" caps or dark grey "wet" caps), uncapped nectar, and the various stages of brood. Of course, it is always a great feeling to see the queen, but sometimes this can be difficult.


IMG 8422


Sometimes the queen is less visible, but the worker activity and movement around her gives her away - the circle of attendants is known as her retinue.


marked queen retinue


When you can't find the queen, evidence that she is there and doing her job is often sufficient. Look for small larva and brood chamber cells with one egg per cell placed neatly in the center of the cell. These eggs will gradually lean over before hatching. Larger larva are good as well, but the very young larva (less than 3 days old) and eggs are a resource - if the hive has to, they can choose one of those to raise a new queen.


eggs and young larvae


You may see eggs that are less perfectly placed - this is usually not ideal. The picture below is from a young queen that was just learning how to do her job and laid two eggs in a few cells. If you see many misplaced eggs, you should be checking to see if you have a laying worker in a queenless hive. A laying worker can only lay drone eggs and the hive will die without a continued population of worker brood.


IMG 7794


The hatched larva will be fed and cared for by the nurse bees (young adult worker bees) and when they are ready to pupate, their cells will be capped. Worker brood will have flat tan/brown caps. In this picture, you can see the progressive brood pattern (capped brood surrounded by progressively younger larva and a pollen border on the edges of the brood chamber).


brood pattern with pollen border


Drone brood will have muffin-top-shaped tan/brown caps and will often be found in "patches" of comb with larger diameter. Such a patch of drone brood can be seen below with uncapped nectar in the nearby cells.


IMG 7747


As the season progresses, you should see a radiating pattern of brood laying and hatching develop within your hive - ideally there will be a ring of pollen around the outside of the brood chamber and capped honey in the top corners of the frames as well. The frame in the picture below is from the center of a well-developed brood chamber mid-summer.


IMG 6977

Pictures Submitted by KT Thompson



Look at that pollen load!!!!!

part0 1


Picture submitted by Tracy Hopkins



Look at that queen cage! During installation of a new package of bees, there is typically a cluster of worker bees around the queen cage - they interact with her and feed her through the screen during shipping and hang on when the keeper removes the queen cage from the main package.


imagejpeg 0 1

imagejpeg 0

Picture Submitted by Joanna Thompson